EOL -End of Line- Testing for AC, BLDC, DC Brush Motors
Nowadays electric motors are subject to 100% inspection following manufacturing.
The M.E.A. Inertial Dynamometer gives the ultimate solution where the conventional dynamometer cannot, since the usage of the conventional dynamometer is often impracticable due to time constraints, cost, and complex setups.
Inertial Dynamometer devices are the ideal testing solution for every type of electrical motor, providing real measurements of the motor output without the usage of modeling. Due to the very fast testing cycle (less than 5 sec) and accuracy of M.E.A. Inertial Dynamometer devices, we have developed our MotorLine systems to meet the demands of testing 100% of the motors on the assembly/production line.
Whether it’s manual or fully automatic, each M.E.A. Inertial Dynamometer device for assembly/production line is a customized solution adapted to the customer’s full-needs.
The supported range of motors is almost unlimited (torque range is unlimited, speed range 5-60,000 rpm).
M.E.A. Inertial Dynamometer devices for the production line can be manual or fully automatic.
Fully automatic Line Manual line
M.E.A. turnkey customized systems include:
- Full conventional motor performance test, from starting to no-load speed
- High Voltage Test
- Insulation Test
- Protective Wire Test
- Vibration and Noise level
M.E.A. Inertial Dynamometers support the following AC motor types:
- Single Phase Induction
- Capacitor
- Shaded Pole
- Single Phase Outer Rotor
- Three Phase Induction
- Three Phase Outer Rotor
- Universal